ToolBox -

Notes:

  1. This machine only supports FAT16 or FAT32 formatted USB drives
  2. SD cards must be 2GB or smaller
  3. Saving might fail if the USB flash memory features password protection or other security features
  4. Only connect USB flash memory to the USB slot
  5. Insert the USB drive directly into the media slot
  6. Do not remove the media while data is being written. Doing so will result in corrupted data.

1. Press the [Home] key on the top left of the control panel, and press the [Scanner] icon on the [Home] screen.

Screen Shot 2013-08-08 at 3.05.07 PM

 

2. Insert a removable memory device in the media slot. You can connect only one removable memory device at a time. The media slot cannot be used if both an SD card and a USB flash memory are inserted into it at the same time.

3. Make sure that no previous settings remain. If previous settings remain, press the [Reset] key.

4. Place originals.

5. Press [Store File].

6. Press [Store to Memory Device].

7. Press [OK].

8. If necessary, specify the scan settings according to the original to be scanned.

Screen Shot 2013-08-12 at 2.49.54 PM

9. Press the [Start] key. When writing is complete, a confirmation message appears.

10. Press [Exit].

11. Remove the memory device from the media slot

 


If you have any questions after reading this article or if you need any help, please don't hesitate to contact the iSchool IT Help Desk.

http://ischool.uw.edu/help
(206) 616-3086